Find or Sell any Parts for Your Vehicle in USA

Gm 4.3l Parts/sensors Lot-map,tps,ignition, More For Tuneup Or Troubleshooting! on 2040-parts.com

US $90.00
Location:

Raleigh, North Carolina, US

Raleigh, North Carolina, US
Returns Accepted:ReturnsNotAccepted Warranty:No

 LARGE lot of parts for 1994 Chevy S10 LS with 4.3L "Z" engine (TBI) and many others. These parts fit MANY GM vehicles with the very popular 4.3L V6 engine. Great for tune-up or troubleshooting!

Check the price on the plugs and wires alone, and you'll see what an awesome value this is.

Some parts new, some used, some barely used. These parts fit many other vehicles; I have tried to be complete in listing part numbers as they appear on the various bits, so that you can confirm compatibility for your vehicle. Check carefully before bidding. Be sure to check out the pictures, as I've gone to great pains to take good photos for your convenience.

Why do I have such a mish-mash of new and used parts? In an effort to diagnose an issue with my truck, I tried a large number of parts. The issue turned out to be a failing fuel pump. Every one of these parts has been testing, working, on my vehicle except the new items, which were never installed. If you think you might have a bad sensor, buying all new ones would cost hundreds of dollars, not to mention the time wasted in buying one sensor, realizing it's not the problem, running back to the store over and over, etc.

I no longer have the truck, and I need to make room in the garage, so you get this awesome opportunity for a tuneup for your truck, sensors for testing, or just to have spare parts on hand. Low starting bid and FREE shipping make this a "must have" for anyone that owns one of these trucks!

Did I mention free shipping?

Picture referenceVendorPart numberDescriptionCondition
1Champion780406Ignition wire set, 7mm, fitted for 1994 S10 4.3L, for 6 cylinder enginesNew
2Federated/4 Seasons45975 K2Idler pulley/Tensioner Pulley (pulley and bearing)New
3Carquest/Wix86481CarQuest Premium Fuel FilterNew
4AC DelcoCR43TSAC Delco Spark Plugs, CR43TS, set of sixNew
5GM06681 E0474Throttle Position SensorUsed
6GM16:28261 1060Ignition Control ModuleUsed
7GM039 4059Manifold Absolute Pressure (MAP) SensorUsed
8GM77905 B0564Idle Air Control (IAC) valveUsed
9GM369 4J12Ignition Module (under distributor) (identical to #10)Used
10GM369 4B07Ignition Module (under distributor) (identical to #9)Used
11DuralastUnknownDistributor Cap and Rotor setBarely Used
12Mr. Gasket9751Chrome-plated ignition wire looms with colored grommets, for 7mm and 8mm wiresNew
13Mr. Gasket9728Plastic wire separators (2x2-gang,2x4gang,1x3gang) for 7mm and 8mm wiresNew

I will also throw in some new dielectric grease for the spark plug wire boots.

As I said, every single used item has been installed on my vehicle and verified working. Sold as-is, however, because I can't guarantee compatibility with your vehicle, and due to used status.

NHTSA announces Kia, Hyundai recalls

Tue, 03 May 2011

The National Highway Traffic Safety Administration said Tuesday that Hyundai Motor Co. is recalling almost 60,000 Kia Spectras from the 2004-2007 model years because of fuel-tank straps that can corrode over time. According to NHTSA, one or both straps can break, letting the tank drop to the ground.

Who's Where: Chris Chapman appointed as Hyundai Chief Designer

Fri, 23 Dec 2011

Former BMW designer Chris Chapman has been appointed as Hyundai's Chief Designer, based at its design center in Irvine, California. He will be responsible for both advanced and production design for the Korean brand and replaces Phil Zak, who left the company early in 2011 to return to GM. He will report to SukGeun Oh, Head of Design, Senior Executive Vice President Hyundai Design Center.

Rolls-Royce Phantom Drophead Coupe

Tue, 09 Jan 2007

By Ben Oliver Motor Shows 09 January 2007 05:53 Drophead Coupe makes waves in Detroit CAR Online brought you the first pictures of the new open-top Phantom and exclusive video footage last month, but this £260,000 monster still stole the Detroit show when Rolls-Royce chairman Ian Robertson officially unveiled it in what will be by far its biggest market. The 100EX concept on which the production car is based stole the 2004 Geneva show too, and features which we all thought would only be seen on the concept, such as the teak ‘decking’ on the hood cover and the rear-hinged suicide doors, have made it to the finished car. Production starts at Goodwood this summer.