Kawasaki H1 500 Ka6 Carburetor Vm28sc on 2040-parts.com

 Up for sale is a KA6 Kawasaki H1 500 Carburetor not fully complete. I will explain. First off I Chem diped this, then wd40 soaked it. Its not perfectly clean but Id bet its clean enough for you to set it up for the bike you want to use it on and run it. Took it apart to see what it has and doesn't have. No guessing here. I have 100% positive feedback and describe everything to the best detail that I can. Much better than those guys that say here they are with no details and then say ask questions.

USA shipping only. 

This carb has the original Mikuni air screw and spring, Has the original Mikuni needle #5DJ19, It has the factory Mikuni float, a bit dented like they all are of its age. The carb clamp that holds it to the manifold is missing the square 10mm nut and hold washer. This has the original 2.0 throttle slide in good shape. It is missing the throttle slide spring. It has the original needle jet 172#0-4. The main jet appears to be a 92, should be a 92.5 R for an H1 D or E or a 90 for a H1F.  So in my opinion it is incorrect so I am throwing in a few aftermarket main jets. Not sure if that will help ya but hey I don't need them they are yours. I am also throwing in additional aftermarket needle, air screw, pilot and seat. They appear to be from Sudko? Not positive on that. It appears to have an aftermarket pilot jet but it is a #30. It also appears to have an aftermarket Float needle valve and seat. The original throttle stop is there but its not straight. Its missing the throttle cable adjuster but the threads look fine, also missing the choke assembly but the threads look fine. No float bowl gasket or slide cap seal either.  No cotter pin for the throttle stop either. Hey its clean and a great body with many great original Mikuni parts for a rebuild

Ask questions if you have any. All the info is there for the reading, but I am a social kinda guy and will answer any question you may have.

Good luck and happy bidding.