Find or Sell any Parts for Your Vehicle in USA

Muncie M-22 Rock Crusher Four Speed Transmission - New Gears - Show Car Quality on 2040-parts.com

US $1,695.00
Location:

Plymouth Meeting, Pennsylvania, United States

Plymouth Meeting, Pennsylvania, United States
Condition:Remanufactured Brand:Muncie Other Part Number:3857584 Manufacturer Part Number:3851325 Surface Finish:Clear Coated Aluminum Interchange Part Number:3831707 Country of Manufacture:United States UPC:Not Applicable

For sale is a Close Ratio Transmission for 63 thru 74 GM products including Grand Sport Corvette, Chevrolet, Oldsmobile, Buick and Pontiac and is a rare opportunity to own a virtually brand new M-22 Close Ratio Rock Crusher Transmission with a completely new gearset. This transmission is a direct replacement for a Borg Warner T10, Saginaw, M-20 or M-21 with no other changes necessary to swap into your vehicle. If you are replacing a 27 spline Muncie M-20 or 21 your existing shifter will swap over. This is about as close to a factory supplied transmission as you can get. #3851325 1" Case Assembly, #3857584 27 Spline Mainshaft Extension Assembly with passenger side speedo, #3831707 Shift Cover Assembly and Aftermarket Bearing Retainer.

Be very wary of some of the sellers on E-Bay listing transmissions with new gears but photographs depicting used gears, the use of silicone instead of gaskets, high quality gaskets and High Tack Gasket Sealant only. 

DO NOT purchase a transmission without French Locks on the front bearing retainer, there is a good chance the bearing retainer will loosen from throw out bearing vibration, only GM type French Locks on my Transmissions! 

Some are even depicting Saginaw`s as M22`s! 

DO NOT  purchase an M22 without a drain plug, you will have no way to effectively remove all of the gear lube including metallic particles that will continue to circulate and eventually lead to premature failure.

All my transmission cases have the Countershaft bores re-bored using a parallel boring process where the counterbore and the mainshaft are truly parallel. This process also produces a virgin counterpin opening thereby assuring a tight, leak free press fit.  

All my photographs are of the actual transmission you will receive. Be very wary of sellers using file photos or multiple product sales, you may be disappointed when the transmission you thought you purchased is not the one depicted in the pictures.

Buy with confidence from a seller that works very hard to maintain feedback satisfaction. Be sure to read my Feedback comments prior to purchasing any Transmissions.

Mystery Muncie First Gear noise eliminated.

And by the way all my M22`s come standard with the Rock Crusher Blower Like Whine!

  • This transmission is completely restored including the following:
  • Case Media Blasted and finished with VHT (2000 degree) high temperature coating.
  • All exposed hardware replaced with hardened bolts.
  • New Auto Gear Lightened Mainshaft.
  • New Auto Gear Shift Shafts that accept all year shift levers.
  • New Bearing Retainer.
  • New French Lock Retainers.
  • New input shaft oil slinger.
  • New input nut.
  • New 10 Spline Input Gear.
  • New First Gear.
  • New Second Gear.
  • New Third Gear.
  • New Reverse Idler Shaft.
  • New Front Reverse Idler Gear.
  • New Rear Reverse Idler Gear.
  • New Reverse Gear.
  • New Front and Rear Bearings.
  • New Cluster Gear, Bearings and 1" Cluster Shaft.
  • New Mainshaft to Input Pocket Bearings. 
  • New Synchronizer Rings, Keys and Springs
  • New Locking Synchronizer Sliders and Hubs.
  • New Cluster Gear Shims.
  • New Rear Gear Countershaft Shims.
  • New Gasket Set Throughout.
  • Fill and Magnet Drain Plug included.
  • New 8 Tooth 1.8" OD steel speedometer circle gear.
  • New Speedo Bullet.
  • New Auto Gear Shift Forks.
  • New Side Cover Spring.
  • The following seals were replaced: Speedometer, Reverse Shifter, Tailhousing Seal & Side Cover seals.


    Case # 3851325 with 1" Countershaft, including Magnetic Drain and Fill plugs. No Vin or Date Code.
  • Aftermarket Bearing Retainer
    Tailhousing # 3857584.
    Side Cover # 3831707 Side cover pin replaced with Hat Style Pin which prevents dislodging. 
  • Please note that all my transmissions are sold without a pencil gear as every application is different ie: Tire Diameter and Rear End Gearing.
  • 2.20:1 First Gear, 2nd 1.64:1, 3rd 1.28:1, 4th direct, Reverse 2.59:1.
    10 spline input
    27 spline output

Will fit the following cars manufactured between 1963 and 1974: All General Motors products including Chevrolet, Oldsmobile, Buick and Pontiac. 

INTERNATIONAL SHIPPING AVAILABLE. SUBMIT SHIPPING ADDRESS RECOGNIZABLE TO UPS FOR FREE QUOTE.

Contact Paypal for very economical short or long term financing. Don`t let financing get in the way of fulfilling your needs. 

Top Gear in the Middle East: Israel & Jordan &…

Wed, 20 Oct 2010

Top Gear filming a road trip in Israel & the Middle East As we said back at the end of September when we reported that Top Gear were busy filming for the next series in New York, this is the time of year when Messrs Clarkson, Hammond and May get to travel the world playing at Four-Wheel-Whickers. September was the USA – ending up in NYC – and now the weather’s getting cooler in North America they’ve ventured off to the Middle East. It looks as if Top Gear are busy filming an epic roadtrip across chunks of the Middle East.

Audi A3 E-tron concept (2011) first official pictures

Tue, 19 Apr 2011

This is the Audi A3 E-tron concept, just unveiled alongside the new Q3 SUV at the 2011 Shanghai motor show. It’s Audi’s second A3 concept car in the space of two months – the first was a 402bhp super saloon, but this is a little more eco-conscious, with a plug-in hybrid powertrain – but both preview how the next A3 will look. Does this new Audi A3 E-tron concept still use the first concept's turbocharged 2.5-litre five-pot engine?

Subaru BRZ Turbo confirmed

Tue, 06 Dec 2011

Subaru BRZ Turbo - which should be good for 300bhp Subaru in the US has confirmed that they are planning to build a turbo version of the new Boxer engine in the BRZ to create the Subaru BRZ Turbo. Finally, after promises that it was on its way for what seems like ever, we saw the arrival of the production versions of the Subaru BRZ and Toyota FT-86  at Tokyo (which had a small name change and arrive as the GT86). But what was a disappointment was that despite Subaru saying the BRZ would come with ‘less than 300bhp’, it actually came with almost exactly the same power as the GT 86 – a much less enticing 200bhp.