Neuspeed Power Module 64.10.14 Add Hp!! Vw Audi Volkswagen Plug And Play on 2040-parts.com

Only used for about 3k miles. Only removed it to bring car back to stock. Would not consider keeping car without it. Improvement in power is really really really worth it! Fast shipping! NEUSPEED Power Module is a device which easily allows anybody to upgrade the performance of their 1.8 TSI and 2.0 TSI (Gen 2.5 or Gen3 engine) without reducing the reliability or integrity of the engine, clutch and driveline. This is the simplest and best alternative or option to chip tuning. The NEUSPEED Power Module is an all new design, not some rebranded 3rd party product. It is a plug and play box that intercepts at the MAP and Boost sensors and can be installed or removed within minutes without any detection. There is a convenient two position switch for premium fuel and 100+ octane race fuel for maximum HP output. The electrical components are housed in a billet aluminum enclosure which is protected from the elements and is designed and manufactured to be positioned within the engine bay of your vehicle. The wire harness is manufactured using automotive quality wiring which is both oil and heat resistant, and has the same OE water proof connectors as used on your engine.   Two position switch: Premium Fuel / 4 PSI Increase 100+ Octane Fuel / 6 PSI Increase   Power / Torque Gain: 1.8 TSI: 35+ HP /  35 ft./lbs.Torque 2.0 TSI: 40+ HP /  40 ft/lbs.Torque   Features:   Increases boost by modifying the charge pressure and map sensor readings Allows ECU to remain in control of boost The actual boost is increased by a precise amount Boost is increased in a gradual, progressive fashion Uses the closed loop control of the ECU to increase boost Readings in the vacuum region are stock No effect on cold start No effect on warm-up No change to idle, cruise and moderate acceleration modes of operation Retains stock ECU programming No change to factory ECU programming, communication or safety protocols No ECU TD1 code to void manufactures warranty Not effected by ECU reprogramming by the dealer Makes use of existing ECU programming for higher boost levels Correct fuel and timing is maintained  Easy Installation Plug-and-play intercept at Boost and MAP sensor connector locations Installation or removal can be completed in a few minutes No trace Power Module was ever there after removal Notes:   Fits: 2013.5-15 VW Jetta GLI & Turbo Beetle 2.0 TSI 210HP and 2014-15 Beetle, Golf 7, Jetta & Passat 1.8 TSI engines.   CARB Pending. Emission testing to be California compliant and any states that follow.   Designed and Engineered Camarillo, California. Made in USA   NOTE: When increasing turbo boost on the 1.8 TSI or 2.0 TSI engines the P-Flo Intake and Hi-Flo Discharge Pipe are recommended.