Find or Sell any Parts for Your Vehicle in USA

New Oem Mercury 5hp 5m 4-stroke Outboard Engine on 2040-parts.com

US $1,540.00
Location:

Farmingdale, New Jersey, US

Farmingdale, New Jersey, US
Returns Accepted:ReturnsNotAccepted Brand:MERCURY Engine(HP):5

Please call us at 732-751-1200 or send us a message before ordering. While we do our best to keep these in our warehouse we do occasionally run low on quantities because we also have a merchant website and walk-in store.

NEW OEM Mercury 5HP 4-Stroke Outboard Engine .

This is covered by Mercury's 3-Year Warranty. 
It is brand NEW in its box.

We are an authorized Mercury/MerCruiser dealer and service center.


5M FourStroke Specifications:
HP @ Prop: 5
kW @ Prop: 3.7
Max RPM (WOT): 4500-5500
Cylinder/Configuration: 1
Displacement (CID/cc): 7.5/123
Bore & Stroke (in): 2.32in x 1.77in
Bore & Stroke (mm): 59mm x 45mm
Cooling System: Water-cooled with thermostat

Fuel System: Carburetor
Fuel Induction System: 2-Valve pushrod (overhead valve)
Alternator Amp 4 / 2 amp / 50 / 25 watt (optional)
Starting: Manual
Gear Ratio: 2.15:1
Gear Shift: F-N-R

Trim Positions: 6
Exhaust System: Through prop
Shallow water drive: Yes
Shallow water trim range (degrees): 16
Recommended Oil: Mercury 4-Stroke Outboard Oil
Oil Capacity: 300 mL / 10 oz
Fuel: 87 octane/up to 10% ethanol
Integral Fuel Tank (Gal): 0.4 (1.1L)
Shaft Length (inches): 15 in
Dry Weight (lbs.): 55
Engine Protection Operator Warning System: Over-rev & Low oil pressure
CARB Star Rating: 3
Propeller Included
Mercury Marine Outboards
Mercury Marine
EPA StandardMeets or exceeds all Federal
EPA emission standards
California C.A.R.BCalifornia C.A.R.B.
three star rating
for ultra low emissions


How to choose the correct O/B shaft length for your boat:

If mounting directly to a boat transom: Measure from the top of the transom down to the bottom of the hull or keel (lowest point). Measure the area of the transom directly where the engine will be mounted. See diagram below.


If using an auxiliary mounting bracket: With the bracket in the down position, measure from the top of the bracket’s mounting surface down to the bottom of the hull or keel (lowest point where engine will be mounted). Tip: For most auxiliary applications, it is possible to use a longer shaft length than what is called for, provided there is sufficient clearance when the engine is in the up position. This can be especially useful in heavy seas.


If measuring an existing outboard:Measure from the inside top of mounting bracket down to anti-cavitation plate above propeller (this is the largest plate/fin directly above the propeller). See diagram below.

Height Measurement:

Recommended Shaft Length:

14” – 17.25”

15” Shaft (Short)

17.25” – 19.5”

Varies by application – contact boat mfg.

19.5” – 22.5”

20” Shaft (Long)

22.5” – 27”

25” Shaft (Extra-Long)








                   Shipping will cost $65.00 anywhere within the continental United States. 

Acceptable payments are: Visa, Master Card, Discover, Certified Check, PayPal or Personal Checks.  

 If you have any questions or if you need any help with your purchase please call 732-751-1200 

Thank you for your time and interest. 


On Jul-26-10 at 15:53:54 PDT, seller added the following information:


SquareTrade Seal Member
SquareTrade Seal Member
SquareTrade © AP6.0


On Sep-28-13 at 19:33:41 PDT, seller added the following information:

Every buyer gets a MyStoreRewards invitation for cash back

Lamborghini Aventador LP700-4 Roadster (2013) first pictures

Mon, 12 Nov 2012

Lamborghini has chopped the top off the Aventador supercar to create the new 2013 LP700-4 Roadster. The big news? The loss of the Murcielago convertible's hopeless 'umbrella' soft-top, which took a couple of people 10 minutes to erect - but only after much head-scratching and swearing.

Mitsubishi readies concept for … Bangkok?

Mon, 04 Mar 2013

While Lamborghini, Ferrari and McLaren are getting ready for the Geneva motor show, Mitsubishi continues to zig by revealing a concept for the 34th Bangkok International Motor Show. The Concept G4 is a compact sedan powered by a 1.2-liter MIVEC engine with a CVT. Mitsubishi says that the sedan carries the company's next-generation styling, including a diamond motif in the front grille, new headlights and an aggressively styled rear fascia.

Daihatsu A-Concept

Tue, 26 Jul 2011

The 19th Indonesia International Motor Show currently taking place in Jakarta saw the world debut of the Daihatsu A-Concept. Developed by Daihatsu's Indonesian subsidiary, ADM, the A-Concept is said to be the end product of a thorough study into the wants and needs of the Indonesian market. Named after the first letter in the alphabet, the concept is said to symbolize the start of a new life for Indonesian society.