Siemens 220lb 2310cc Low Impedance Injectors 110333 on 2040-parts.com

Price is high due to availability if you want to make balls to the wall power, with an injector that will out flow it's advertised specs and run any fuel type these are what you want to look at.

Flow Rate in CC per minute: 2433 CC/min @ 43.5 PSI
high Flow Rate in LB per hour: 220 LBS/HR @ 43.5 PSI
Resistance: 2.27 ohms (Low Impedance, Low Resistance)
Voltage: 8-15 Volts, nominal 13.5 Volts
Pressure: Min 30 PSIG/ Max 100 PSIG
O-Rings Included: none
Injector Body Design: Metal and composite plastic
Fuel Delivery: Upgraded single fuel delivery nozzle for superior fuel atomization
Offset: 0.64ms
Turn on time: 1.5ms
Turn off time: 1.3ms
Series: DEKA 4 ( DEKA IV )
Electrical connector type: Bosch EV1 (Minitimer, Jetronic)
Spray Pattern: 10-15 Degree Pencil Cone
Orifice Type: Single Orifice
Overall Length: 2 7/8 inches, 74 mm
O-ring to O-ring Length: 2 1/2 inches, 63 mm
Diameter: 16 mm

These injectors flow 220 lbs/hr at 43.5 PSI ( 3 BAR ) and more at higher PSI! These units are low-impedance and require peak and hold injector drivers or additional resistors for saturation drivers. Despite the flow rate, they are linear and controllable at low pulse widths compared to other extreme flow injectors! These injectors are sometimes referred to as 212lb/hr or 225lb/hr injectors.

These injectors will allow you to run methanol, ethanol and other flex fuels with fewer injectors for high horsepower applications. Don’t settle for questionable modified low flow injectors when you can have Genuine Siemens quality and performance with these injectors. These injectors are perfectly suited for Extreme horsepower turbo & supercharger applications.

Price is high due to availability