Euro software program for Snapon solus ultra scanner. This will install European software to your solus ultra. For obd2 European cars only. Includes landrover, Volvo, Volkswagen, Audi, BMW, Mercedes.
This card doesn't upgrade your software, just installs European vehicles. Thank you for looking.
Email with any questions.
Posted with eBay Mobile
Diagnostic Tools / Equipment for Sale
- Auto x-ray ez 6000 scan tool(US $100.00)
- E z bore valve spring tester for flathead engines go karts in hard carrying case(US $29.99)
- timing gage set(US $40.00)
- Equus 3100 innova can0bd2 diagnostic tool new in box(US $0.99)
- Ba101s 12v auto smart battery failure alert tool alerts you before battery dies(US $25.00)
- Rac tach dwell meter(US $9.99)
Audi A3 g-tron revealed
Fri, 01 Mar 2013Audi has revealed the A3 g-tron Sportback ahead of the Geneva Motor Show, an A3 that runs on Compressed Natural Gas (CNG) and petrol. The A3 g-tron is powered by a tweaked version of Audi’s 1.4 litre TSI petrol engine which can run on both -gas and petrol, with the A3 g-tron normally using the petrol just for start-up and switching over to e-gas as soon as it’s running. Audi has provided two fillers under a common fuel flap – one for e-gas and one for petrol – with the A3 g-tron producing a total of 108bhp with the dual-fuel setup, enough to power the A3 g-tron to 62mph in 11 seconds.
No more Top Gear until 2013, says Jeremy Clarkson
Wed, 09 May 2012No new Top Gear Series until 2013 Top Gear leader Jeremy Clarkson has revealed to South African Sasha Martinengo on Ballz Radio that there won’t be a new series of Top Gear until 2013. Under normal circumstances we’d expect a new series of Top Gear to arrive in the Autumn of 2012. But it seems not.
Ford invents agile, low-cost solution for prototyping, customization and limited production [w/video]
Wed, 03 Jul 2013A new metal forming technique pioneered by Ford that drastically reduces the time and cost of producing low-volume and one-off body parts may lead to cost-effective customization, redesigns, one-offs and limited production runs. Ford Freeform Fabrication Technology (F3T) forms sheets of metal by two stylus-like tools, one on each side of the surface. Using CAD data they form the part to the exacting strength and finish tolerances usually associated with stamping dies.