Find or Sell any Parts for Your Vehicle in USA

Stop Marine Electrolysis Corrosion Rust Current Leakage Yacht Boat Battery Sea on 2040-parts.com

AU $545.00
Location:

Adelaide, SA, Australia

Adelaide, SA, Australia
Condition:New Brand:Seabis Manufacturer Part Number:Does Not Apply

This electronic device picks up the smallest amount of stray current leakage that is near impossible to find any other way . Electrolysis is the accelerated corroding / rusting of a metal in salt or fresh water due to an electrical current passing through that metal . This SEABIS microprocessor will detect any electrical current from 10 volts to 32 volts and down to 10 millionths of an amp and it is the amps not the voltage that causes damaging electrolysis .  
  Seabis is easy to use , connect the positive lead to the positive battery terminal on the battery bank , negative to the negative and the earth to the engine which is the common earth . Any current will be detected if no ELECTROLYSIS then either one of the top 2 GREEN LED lights will illuminate . If harmful stray unwanted current leaks are detected either the right or left RED LED will light up these are in the middle of the device and are clearly marked " Serious " below this is another 2 RED led's which are marked "Critical " . There are 2 banks of LED's because the left side refers to the POSITIVE Battery terminal which indicates stray current flowing into the positive battery terminal while the right side indicates current flowing away from the negative terminal . There are also 2 YELLOW LED's which show very small not as serious electrolysis current in the system .  
   The only way to stop electrolysis is to constantly monitor for these damaging current leakages 100% of the time because current leakage will increase under load , with higher humidity , with worn or wet electronic or electrical equipment such as ; Winch , Pump , Radio , Navigation Lights , Generator , Alternator , Starter Motor , absolutely anything powered by electricity . The SEABIS device clearly shows that there is electrolysis damaging current flow and by isolating the equipment that is allowing electrolysis to corrode away metal the problem can be fixed .  Temporally disconnect a device and if the " GREEN LED " lights up instead of the " RED LED " then the culprit has been found and once repaired / rewired will no longer cause electrolysis .     
  There is also another " RED LED " right in the centre of the SEABIS which is marked " AC only ALARM " this will pick up AC ( Alternating Current ) that IS leaking into the DC system and damaging the batteries in the battery bank . This AC current can also be EXTREMELY dangerous to the occupants on the vessel and a qualified electrician should be call immediately .  
  The SEABIS unit comes with detailed 13 page instructions booklet titled " HOW TO STOP METAL CORRISION ( ELECTROLYSIS ) . " More detail technical information can be found @ www.seabis.com  . So if you have a electrolysis problem and wish to eliminate the corrosion permanently or wish to guard against any future problems with accelerated electrolysis causing severe corrosion of propellor , drive legs / outboard leg , skin fittings , gearbox ,  radiator and steel aluminium aluminum hulls ....   

    MADE in AUSTRALIA .   Over 1,000 Seabis electrolysis elimination devices currently in use through out the World today !
                                                Seabis is sold and in used in Australia , New Zealand , United States , Canada , United Kingdom , 
                                                Singapore , Hong Kong , Philippines , South East Asia , South America , Russia and France . 

   Will pack extremely well and post to ANYWHERE within Australia via trackable EXPRESS free of charge . International enquiries welcome packed item weighs just under 1 kilo and measures 24 cm's x 18 cm's x 12 cm's . The SEABIS itself has 2.5 meter of flexible cable can be hand held or mounted . The SEABIS measures 19 cm's x 10 cm's x 3 cm's . 
 SEABIS comes with an EIGHT YEAR guarantee AND 8 year warranty !!!! so please check the SEABIS.COM website for all the details / conditions , thanks .      
  

2010 Mercedes E-Class leaks out

Wed, 10 Dec 2008

The interweb is a mine of information, much of it less than convincing, but you can be sure that there is little under the sun that won’t find its way there. And so it is with what certainly appear to be real images of the 2010 Mercedes E-Class. There have been spy shots of the new E-Class around for some time.

CES 2011 opens in Las Vegas

Thu, 06 Jan 2011

The pace of development in the world of consumer electronics – particularly touchscreens, smartphones and tablet devices – is increasingly influential on the world of automotive design. So with the world's biggest electronics trade show, the 2011 Consumer Electronics Show (CES), opening today in Las Vegas, we thought it high time for Car Design News to attend.  The 2011 show has a strong automotive flavor, more so than in any previous year. CES was the event at which Ford chose to launch its industry leading in-car connectivity feature, Sync, in 2008 and, for the third year running, Ford CEO Alan Mulally will deliver a keynote address, during which he is expected to unveil Ford's Nissan Leaf-rivaling, electric-powered Focus.

Jaguar XFR Review: On the Road

Mon, 27 Jul 2009

The Jaguar XFR has quite astonishing - and controllable - performance You start to wonder if Jaguar has screwed up and put the normally aspirated version of the potent V8 in the XFR. This can’t be an M5 competitor – it’s just too civilised. The ride is cosseting and compliant, but with an underlying – and reassuring – firmness.