Walker Exhaust 47696 Exhaust Pipe-exhaust Intermediate Pipe on 2040-parts.com
Chino, California, US
Exhaust Pipes & Tips for Sale
Walker exhaust 41828 exhaust pipe-exhaust tail pipe(US $25.53)
Walker exhaust 43975 exhaust pipe(US $78.80)
Walker exhaust 47708 exhaust pipe-exhaust tail pipe(US $62.23)
Walker exhaust 53352 exhaust pipe(US $201.70)
Walker exhaust 41761 exhaust pipe(US $40.93)
Walker exhaust 43907 exhaust pipe-exhaust intermediate pipe(US $15.81)
Frankfurt 2011:Rimac Concept One – an Electric Supercar
Sun, 18 Sep 2011Rimac One Concept - an electric hypercar at Frankfurt Our antipathy towards electric cars – and the seeming futility of pursuing a technology that has made little progress in a century – is well known. But we do see electric cars as a fun toy for the better-off, and 23 year-old Croatian Mate Rimac has impressed Frankfurt with his Rimac Concept One electric supercar, which is perhaps the ultimate electric toy for the better-off. Perhaps, in the case of the Rimac One, we should consider it a toy for the seriously well-off, rather than just the better-off, as it’s expected to cost a quite substantial £650k for each of the 88 cars Mate intends making.
Saab 9-3 Convertible Independence Edition
Sat, 19 Feb 2011The Saab 9-3 Convertible Independence Edition Last week we ran a story about Saab’s Concept for the Geneva Motor Show, which we expect to be a concept version of the new Saab 9-3, but could be a first look at the smaller Saab 9-2. What we did say in that report was that apart from the Saab Concept we would see the debut of the Saab 9-5 SportCombi and a couple of limited edition Saab 9-3s – one of them a convertible. Well, with a week or so to go to the Geneva Motor Show, the limited edition Saab 9-3 convertible has leaked out through the well-informed Saabs United as the Saab 9-3 Convertible Independence Edition.
Webinars: Technical Surfacing from Autodesk
Mon, 06 Sep 2010Autodesk's Technical Surfacing webinar, presented by Uwe Rossbacher, Product Manager for NURBS Modeling/Technical Surfacing at the Manufacturing Solutions Division of Autodesk, was presented on September 21, 2010. The webinar was an introduction to professional NURBS* surfacing and a demonstration of how to evaluate surfaces and users' own level of surfacing expertise. View the recorded webinar in our archive by clicking the above link.