Xat Racing Quartermaster Dual Disc Clutch Kit 1uzfe To Cd009 on 2040-parts.com

Listing for 3 days will be in town to ship it out sometime between saturday and monday


1UZ to CD009 clutch set up.
clutch kit xatracing.com/xatqu1uztrpl

XAT Racing spacer(1uz), pilot bearing, extra new nissan pilot bearing, ARP flywheel bolts, button flywheel(1uz), quartermaster 7.25" dual disc clutch set( 350/370z g35/37 splines ) clutch alignment tool

bought this months ago tried installing it with a JK40e was told it works but later told it does not. after busting 2 throwout bearings without even dropping the car off the lift. it apparently works with the CD00X with external slave and push fork with bearing setup but not the internal concentric throwout bearing and slave. Im guessing the kit can work if you mill down the spacer but im not sure of how much nor do i want to spend cash again and again and again after i was sold a "conversion" kit that should just bolt in and go.
The clutch cover has some scarring due to extremely tight spacing between the motor and firewall, the pilot bearing hub has some tap marks because it sit tight in the spacer i had to tap it to pop it out several time, the bearing is smooth but will include a 2nd one in case you want to swap it out. One of the end disc has some scarring for the same reason as the clutch cover the first time i didn't bash the tunnel out enough had wiggle the input shaft in.

Jk40e but wont work with this clutch adaptor setup without external slave conversion which is almost 400-600$ going to be parting out the car to fund another project.

 sold as-is with no returns check part numbers and look at the picture and ask questions before purchasing