Yamaha Yzf-r1 R-1 +4º Degree Ignition Advancer Rotor 1998-2001 By Advancerman on 2040-parts.com

1998-2001 Yamaha R-1 +4º Ignition Advancer

•Above is my R-1 +4º Advancer

An “Advancer” is an ignition rotor that has a different location of the “trigger” points. The trigger points control the ignition by whizzing past the ignition pickup. Usually they are advanced from stock, but like the turbo guys know, sometimes a retarded advancer is needed. Stock ZRX ignition timing is 10 degrees before top dead center at idle. My ZRX +4º is 14 degrees and my +2º is 12 degrees BTDC. The ZRX really can use these. I used to say they did not, but thru my research I learned that there have been advancers with +0.5º out there, that when installed, made virtually zero difference and that is the cause for this inconsistency in performance reports.

My advancers are made with an aircraft Laser, they are on the money! The triggers are all uniform in size, unlike the stock punched-out ones. And, being of 400 Series Stainless, they have greater magnetic pull and make a crisper on-off of the timing pickup. The triggers are all correctly spaced where they should have been from the factory. You bike will more than likely be smoother running.

I have a lot of my advancers on the road now, and everyone has good comments on them. The most interesting comments are smoother running and easier starting...the smoothness is because of the accuracy of the laser cutting. Advancing the timing often lowers the peak coolant temp a bit...an old hotrodders’ trick... and also can raise the gas mileage slightly. The best result is the increased throttle response and roll-on acceleration. You will like my advancers, I am so confident, I am offering a money-back guarantee if you do not. I have sold hundreds with no dissatisfied customers.


•Above picture is of a ZRX1200R with my +4º Advancer
Clear Cover Made By Jason7019, his phone is 269-591-9587

Easy Advancer Advance Pick?
ZRX with stock compression with stock ignition ECU, run +4º
ZRX with 12:1 or 12.5:1 compression motors, or ZRXs with a ZX11D ignition ECU run the +2º
ZX11 with stock compression, run +4º
ZX11 with 12:1 compression, run +2º
Any ZRX1100 or 1200R with ZX11D ECU, with any or no mods: ZX11D +2
ZL900, ZL1000 or ZZR1200 with stock compression, run +4º
Yamaha FZ1 with stock compression, run +4º
Yamaha R-1 with stock compression, run +4º

Again, these are really +2 and +4 degree advancers, created with some pretty exact aircraft laser technology. My Advancers are guaranteed to increase your throttle response, or return for a refund. You’ll like ‘em! ...a lot! Even I’m impressed.     ...true story...

Click on the ZRX Tech link for installation instructions: eBay will no longer let my have the link. Google AdvancerMan for instructions.  Any questions, please call me.

Gasket not included.

Cheers,
Pete/KWICK Aronson
Google "AdvancerMan" for more info & Kool Stuff!
480-961-0643